baggerman.org

bd-4_for_sale

Anonymous (anonymous@undisclosed.example.com) — 2023-08-08T10:16:15+00:00

Bede BD-4 Project Plane Available Have you ever dreamed of building and owning an airplane but worried about the cost or skill involved? Then this partially built Bede BD-4 aircraft project might be right for you. This BD-4 project was started by an experienced builder before his untimely death. It has been sitting in the widow’s garage for 10 years. Now it is time to go.

first_robotics

Anonymous (anonymous@undisclosed.example.com) — 2019-03-19T11:31:12+00:00

FIRST Robotics Setting up a Raspberry Pi with Talon SRX Ideas for FIRST Robot Parts Pneumatics debug board Talon SRX breakout board with screw terminals Talon SRX breakout board with RJ-45 connector Talon SRX sensor breakout board with RJ-45 connector Talon SRX breakout board on inexpensive quad encoder

halliday_history

Anonymous (anonymous@undisclosed.example.com) — 2016-07-12T07:53:38+00:00

Halliday History My Immediate Background My mother is Eleanor Jean HALLIDAY. She is the daughter of William Norman HALLIDAY and Vivian Viola MEECH. Her siblings were Robert (Uncle Bob), Elizabeth (Aunt Betty), Norman (Uncle Norm), and John (Uncle John). Here is a diagram of our family. The purpose of these family history pages is to document and archive our family history for my children and for my relatives' families. I have a lot of paper history that I fortunately carried around for a lot …

raspberry_pi_with_talon_srx

Anonymous (anonymous@undisclosed.example.com) — 2019-01-14T22:49:32+00:00

Using a Raspberry Pi to Run a Talon SRX Motor Controller Configure RPi as a CAN Bus controller apt-get install libsocketcan2 apt-get install libsocketcan-doc Waveshare RS-485 / CAN Hat Waveshare RS-485 / CAN Hat * Make sure latest BCM2835 GPIO and WiringPi libraries are installed. * Use raspi-config to make sure I2C and SPI are enabled

start

Anonymous (anonymous@undisclosed.example.com) — 2024-07-22T15:04:40+00:00

Welcome Welcome to baggerman.org. Baggermans are a small bunch and we are scattered around. Here you will find out a little bit about us. A little bit about me I am Bob Baggerman. I grew up near St. Louis, MO. I graduated from St. Charles High School in 1976. I graduated from Georgia Tech in Atlanta in 1980. I briefly worked for Bendix Avionics in Ft. Lauderdale until 1982. In 1982 I returned to Georgia Tech as a Research Engineer. After living in Atlanta for about 35 years I decided to …

wind

Anonymous (anonymous@undisclosed.example.com) — 2018-12-10T10:24:50+00:00

Bob's Hurricane Wind Speed Logger include “/web/baggerman/wind/libchart/libchart/classes/libchart.php”; Some constants -------------- $PLOT_POINTS = 3601; Get a little data to display ---------------------------- $sLog = “”; exec(